Convert SCFM, CFM, Nm³/h, m³/min, L/s and NL/min with reference-state warnings.
Use the Compressed Air Flow Unit Converter to convert SCFM, CFM, Nm³/h, m³/min, L/s and NL/min with reference-state warnings. The calculator uses Flow value, Source reference pressure, Source reference temperature, Target reference pressure and Target reference temperature and reports converted flow.
Read the result in the context of the selected units and pressure basis. For this tool, the primary outputs are converted flow. Change one input at a time when comparing scenarios so the effect of each variable remains clear.
PneumaForge applies this verified method: Pure scale conversion only for flows on identical reference states. If reference conditions differ, apply combined gas law via ENG-02. The functional engine is shared with related tools in the flow-conversion family, while this page solves the specific intent represented by compressed air flow converter.
Pure scale conversion only for flows on identical reference states. If reference conditions differ, apply combined gas law via ENG-02.Reproducible example: start with the calculator's default values (Flow value = 1000; Source reference pressure = 1.01325; Source reference temperature = 20; Target reference pressure = 1.01325) and calculate the result. Then change the variable most relevant to your application and compare the new converted flow against the baseline.
Reference P,T displayed and editable for SCFM/Nm³/h-like quantities.
It is designed to convert SCFM, CFM, Nm³/h, m³/min, L/s and NL/min with reference-state warnings. The reported outputs are converted flow.
The calculator uses Flow value, Source reference pressure, Source reference temperature, Target reference pressure and Target reference temperature. Only use values that represent the same operating condition or design case.
The calculation follows: Pure scale conversion only for flows on identical reference states. If reference conditions differ, apply combined gas law via ENG-02. The page also states the assumptions that define where the method is valid.
Reference P,T displayed and editable for SCFM/Nm³/h-like quantities.
Yes. PneumaForge converts supported units through canonical engineering units. For compressed-air reference flows and pressure bases, the reference pressure and temperature must also remain consistent.